Yokogawa EXA PH202 2-Wire pH/ORP Analyzer - Manual (Page 81)

IM 12B07D02-01E
Maintenance 7-1
7. MAINTENANCE
7-1. Periodic maintenance for the EXA transmitter
The transmitter requires very little periodic maintenance. The housing is sealed to IP65, NEMA 4X
standards, and remains closed in normal operation. Users are required only to make sure the front win-
dow is kept clean in order to permit a clear view of the display and allow proper operation of the push-
buttons. If the window becomes soiled, clean it using a soft damp cloth or soft tissue. To deal with more
stubborn stains, a neutral detergent may be used.
NOTE:
Never used harsh chemicals or solvents. In the event that the window becomes heavily stained or
scratched, refer to the Customer Maintenance Parts Lists for replacement part numbers.
When you must open the front cover and/or glands, make sure that the seals are clean and correctly fit-
ted when the unit is reassembled in order to maintain the housing’s weatherproof integrity against water
and water vapor. The pH measurement uses high impedance sensors and may otherwise be prone to
problems caused by exposure of the circuitry to condensation.
The EXA analyzer contains a logbook feature which needs a clock to provide the timings. The EXA
instrument contains a lithium cell (battery) to support the clock function when the power is switched
off. This cell needs to be replaced at 5 yearly intervals (or when discharged). Contact your nearest
Yokogawa service centre for spare parts and instructions.
7-2. Periodic maintenance for the sensor system
NOTE :
Maintenance advice listed here is intentionally general in nature. Sensor maintenance is highly
application specific.
The sensor system must be kept clean to function well. This may require regular cleaning of the elec-
trodes. (The effect of dirty electrodes will be to slow the system response and perhaps corrupt the
measuring loop entirely). The frequency of cleaning and the method of cleaning will depend entirely on
the process.
Where a refillable (flowing electrolyte) reference system is employed, make sure that the reservoir is
kept topped up. The rate of electrolyte consumption will again be process dependent, so experience will
show how often you must refill.
The periodic recalibration of the sensor system is necessary to ensure best accuracy. This takes into
account the aging of the sensors, and the nonrecoverable changes that take place. These processes are
slow, however. If frequent recalibration is needed, it is usually because the cleaning process is not effec-
tive, the calibration is not well executed or the pH readings are temperature dependent. Monthly calibra-
tions should be sufficient for most applications.
If a film remains on the pH sensor after cleaning, or if the reference junction is partly plugged, then
measuring errors can be interpreted as a need for recalibration. Because these changes are reversible
with correct cleaning and/or proper selection or adjustment of the electrolyte flow through the junction,
make sure that these items are correct before recalibrating the system.