Spectra Precision Survey Pro v4.6 Ranger User Manual - Manual (Page 104)

User’s Manual – Conventional Mode
94
8. The Cut Slopes and Fill Slopes are
automatically set to the values contained in
the template being slope staked. You can
override these values by checking the
appropriate boxes and changing the values
accordingly. When doing this, the new
cut/fill slopes entered will always be used
regardless of the values stored in the
templates.
Fill slopes do not need to be entered as
negative values since Survey Pro knows
that these are negative slopes.
9. Tap the Fill Hinge Points tab to define
where the hinge point will be computed in
areas that require a fill. Use the << and
>> buttons to select the desired segment.
(The hinge point will be computed at the
end of the selected segment.)
10. Now tap the Cut Hinge Points tab and
define where the hinge point will be
computed in areas that require a cut in the
same way as you did in the previous step.