Spectra Precision Survey Pro v4.6 Ranger User Manual - Manual (Page 332)

User’s Manual – GPS Mode
322
with the available control points and checking the extra
control points for closure. This routine will usually identify
the one or two bad points in a control point set, and then
prompt you to automatically remove these points as control
for the localization. If there is an ambiguous result for the
blunder detection, you will be prompted to collect extra check
points to provide the information needed to correctly identify
the blunders.
• Localization Parameter Checking: Once the localization
solution is solved, hopefully with any potential blunders
identified and removed, Survey Pro will do one last
automated check for localization solution quality. The scale
factor of the solution is checked against a sensible tolerance,
and if it is too large or small, a message will show in the
results area.
In addition to the mechanisms Survey Pro uses automatically
to ensure a quality localization solution, you must also use
good common sense before using the final localization
solution. For a detailed discussion of how to ensure the
quality of the localization solution please see Page R-259 in
the standard GPS section.