Spectra Precision Survey Pro v4.6 Ranger User Manual - Manual (Page 322)

User’s Manual – GPS Mode
312
No matching base found One matching base found
3. Fill in the screen and tap Next>. The
base point name and the precise
geodetic coordinate of the base are
noted in Survey Pro. If you are doing
post processing at the base, the station
name, description, and antenna height
are then sent to the file on the base
receiver for post processing.
Set Up Rover
4. You are prompted to connect to the
rover receiver or will be automatically
connected if using Bluetooth. Once you
connect to the rover, it will begin to
monitor the data link for the base
corrections. You are then prompted to
enter the rover antenna height to
proceed with the setup. If you want to
do post processing data collection with
the rover receiver, select a recording
interval, otherwise leave this set to Off.
More than one matching base found