Spectra Precision Survey Pro v4.6 Ranger User Manual - Manual (Page 314)

User’s Manual – GPS Mode
304
Serial Connection
These steps describe how to configure the software when connecting
to the receivers with a serial cable. This is the default setting and
does not need to be configured unless it was changed.
1. If communicating with both GPS
receivers using serial cables, tap
Change Settings… from the Job >
Settings
> Connection screen.
Note: You could alternatively run the
Bluetooth Setup Wizard and when no
Bluetooth receivers are detected, a serial
connection will automatically be selected.
2. Select Serial for both the Rover and
Base receiver and tap to finish.