Spectra Precision Survey Pro v4.6 Ranger User Manual - Manual (Page 265)

GPS Module
255
Rover Setup – Set Rover
1. Tap Setup HR to select your antenna type
and measure the slant or vertical height of
the antenna.
2. If you are not post processing, leave the
Post Processing Recording Interval
field set
to Off. If you are post processing, select the
desired recording interval in this field. The
receiver will open a file (with the next
available default name), start recording
GPS raw data, and record the station and
antenna information for this static session.
3. Tap SET Rover to setup the receiver as an RTK rover. The rover
will then wait to receive the base reference position over the data
modem link. If you have already configured the base with this
data collector, then the base reference position from Survey Pro
will be checked against the position received at the rover. If you
have not yet configured the base reference position in Survey Pro,
it will be configured with the position received at the rover.
Rover Setup – Set Base Reference Position
When you are using a remote base station, and the base reference
position is not yet known to Survey Pro, you must complete the Base
Setup wizard for the remote base position in order to store the base
position in Survey Pro and update the raw data.
Similarly, when you set the rover and the remote base position
received at the rover is different than the one set in Survey Pro, or
when you are doing RTK surveying and the rover detects that the
base position has changed, you will be prompted to complete the Base
Setup wizard for the remote base position.
1. Choose a name for the remote base point. If the base reference
position received at the rover matches a single point in the job
file, then the prompt to choose a point name is skipped, and
you go to the next step. If the base position does not match
any points in the job file, you are prompted to choose a name
for the new base point to store. If the base position matches