Spectra Precision Survey Pro v4.6 Ranger User Manual - Manual (Page 33)

Getting Started
23
There are different map views depending on from where the map
view is accessed and they can display slightly different information
such as a vertical profile.
The main map view is accessed from the Main Menu by tapping the
button at the bottom of the screen in the command bar. If you are
using basemaps, it is from this map view where the basemaps are
managed.
All other map views are accessed by tapping the button from a
variety of screens.
A bar is shown at the bottom of every map view that indicates the
scale.
The buttons along the left edge of the screen allow you to change
what is displayed in the map view.
Tip: You can pan around your map by dragging your stylus across the
screen.
Zoom Extents Button: will change the scale of the screen so that
all the points in the current job will fit on the screen.
Zoom In Button: will zoom the current screen in by
approximately 25%.
Zoom Out Button: will zoom the current screen out by
approximately 25%.
Zoom Window Button: Allows you to drag a box across the
screen. When your finger or stylus leaves the screen, the map will
zoom to the box that was drawn.
Zoom To Point Button: Prompts you for a point name and then
the map view will be centered to the specified point with the point
label displayed in red.
Turn To Point Button: Tap this button and then tap a point in
the map view to automatically turn the total station to the selected
point. This is only available when a robotic total station is selected
and Remote Control is active in the Instrument Settings.