Spectra Precision Survey Pro v4.6 Ranger User Manual - Manual (Page 202)

User’s Manual – Leveling Mode
192
respectively.
10. If everything on the screen is acceptable, tap
Store Observation to continue. You will return to the Level
screen shown in Step 6.
If the completed shots were for a turning point or benchmark,
you are expected to advance to the next setup where your
previous foresight will become your new backsight. If you
completed a side shot or stakeout shot, you will remain at the
current set up to shoot additional points.
Turn to Benchmark
11. This option should be used whenever
you will be shooting any benchmark
other than the starting benchmark.
(The starting benchmark is always the
backsight for the first shot in a level
loop.)
Enter the benchmark point in the BM
Point field. If this is a closing
benchmark, this point must already
exist in the current job.
Shooting a benchmark other than the
closing benchmark is similar to shooting a turning point,
except the benchmark will either be stored as a new point, or
if the point already exists, the elevation, or the elevation and
coordinates can be overwritten with the values from this
routine.
12. Tap Next > to continue.
Note: If you are intend to shoot your closing benchmark and
accidentally tap Turn to Turning Point instead of Turn to Benchmark,
you can simply tap to cancel out of that screen and return to the
Level screen where you can then make the correct selection.