Spectra Precision Survey Pro v4.6 Ranger User Manual - Manual (Page 237)

GPS Coordinates in Survey Pro
227
Tapping Localization opens the Solve Localization routine. This
routine is described on Page 259 for when running the GPS module
and on Page 320 for when running the Basic GPS module.
Tapping Switch to TDS Localization will switch from Mapping Plane
mode to TDS Localization mode.
TDS Localization Mode
Tapping Reset Origin will open the screen to manually key in the
parameters for the default map projection zone used in the
localization adjustment as described on Page 228.
Tapping Solve Localization will open the Solve Localization routine.
This routine is described on Page 259 for when running the GPS
module and on Page 320 for when running the Basic GPS module.
Tapping Switch to Mapping Plane will switch from TDS Localization
mode to Mapping Plane mode.
Localization Default Zone
When your horizontal projection mode is Ground – TDS Localization,
there is usually no need for you to setup the map projection zone
used. Survey Pro will initialize a default map projection, scaled for
ground distances, when you set the first RTK base in the survey.
You can reset this default zone in two ways. First, you can key in
parameters by hand, or you can select a Ground – TDS Localization
coordinate system from the database. The Localization Set Zone
screen can be used to modify the default map projection zone used.
You may wish to do this when your base is more than 100 m higher or
lower than the survey area in order to have the correct ground scale
factor used. The Select Coordinate System screen can be used to
select a zone or site record from the TDS Localization region
collection in the coordinate system database.