Spectra Precision Survey Pro v4.6 Ranger User Manual - Manual (Page 239)

GPS Coordinates in Survey Pro
229
Localization Select Zone
You can store and select any coordinate system in the database file
using Save System to Database on the Projection Show Details screen.
Coordinate systems stored in Ground – TDS Localization mode are put
in a special region called TDS Localization region. To select Ground –
TDS Localization
coordinate systems from the database, open the
Select Coordinate System screen from the Localization Set Zone
screen. The procedure for selecting a coordinate system is the same
as the Mapping Plane mode case, which is described below.
Mapping Plane Select Zone
Use the Select Coordinate System screen to select either a mapping
plane zone or a localized site from the coordinate system database
file. This screen is also used to open the Key In Zone wizard where
you can key in the parameters of a custom map projection and datum.
1. Open the Select Coordinate System
screen. This may be done automatically
by the Start GPS Survey wizard, or
when you tap Select Zone… on the
Horizontal card of the Projection screen
when in mapping plane mode.
2. Select the type of database record you
wish to choose in the Data Base box. To
pick a map projection zone from the
database, tap Select Database Zone. To
pick a localized map projection site
from the database, tap Select Database Site.
3. If you are picking a map projection zone, select the Zone
Group
from the drop down list.
4. Select the Zone or Site from the drop down list.
5. If you have selected a zone with a datum, the datum name
will be displayed. If you have selected a zone without an
attached datum, such as the database UTM zones, you must
select a Datum from the drop down list.