Spectra Precision Survey Pro v4.6 Ranger User Manual - Manual (Page 263)

GPS Module
253
Base Setup Two – SET
The Base Setup Set screen is used when the geodetic coordinate of the
chosen base reference point is known or can be calculated.
5. If you are post processing, select the
desired recording interval in the Post
Processing Recording Interval
field. The
receiver will then open a file (with the next
available default name), start recording
GPS raw data, and record the station and
antenna information for this static session.
If you are not post processing, leave this
field set to Off.
6. Tap SET to start the base receiver
broadcasting this reference position and
GPS observations over the radio link, and to configure the base
reference position in Survey Pro.
Base Setup Two - GET and SET
The Base Setup GET and SET screen is used when the geodetic
coordinate of the base reference position is not known. In this case,
you must GET an autonomous position from the GPS receiver, then
you can SET this as the reference position.
7. Tap GET Position From Rx to get an
autonomous position from the receiver. If
you wish to get an averaged position, enter
a number in Average position [n] epochs
before GET
.
8. If you are not post processing, leave the
Post Processing Recording Interval
field set
to Off. If you are post processing, select the
desired recording interval in this field. The
receiver will open a file (with the next
available default name), start recording
GPS raw data, and record the station and
antenna information for this static session.
9. Check the results displayed in the edit boxes. If it looks good, tap
SET to start the base receiver broadcasting this reference position