Spectra Precision Survey Pro v4.6 Ranger User Manual - Manual (Page 36)

User’s Manual
26
Basemaps are drawn to the screen in the
reverse order that they are listed in the
Manage Basemaps screen, where the first
basemap in the list is the last one drawn,
and thus, will be drawn "on top" of any
other basemaps. This is important to
remember if any basemaps overlap since if
a raster basemap were drawn on top of
another basemap, it would cover any
basemaps below it.
The list shown contains a vector basemap,
tds.dxf that occupies the same area as the
other two basemaps, which are raster
basemaps. The vector basemap is at the
top of the list so the points and lines it
contains will be drawn last and appear on
top of the two raster basemaps.
6. To change the order of the basemaps in
the list, select a basemap and tap the
Move Up or Move Down buttons to
move it up or down in the list,
respectively.
7. To remove any basemap from the list,
select it and tap Remove . This will
remove the basemap from the list and
un-associate it from the current job.
(This will not delete the corresponding
basemap file.)
Raster basemap drawn first.
Vector basemap drawn last.
Resulting map view with both basemaps in
view.