Spectra Precision Survey Pro v4.6 Ranger User Manual - Manual (Page 288)

User’s Manual – GPS Mode
278
measurement. When you are satisfied with the measurement tap
Accept to return to the Data Collection screen
8. Check the Results tab for details on the last measurement. Check
the Map tab to see the points plotted as they are stored.
Topo SS
Use this method if you want to store a point at the current rover
position. When you tap Topo SS, Survey Pro will check the current
position against the measurement criteria. If the position is good,
then Survey Pro will store the point. You may be prompted for
description, layer, and/or attributes depending on your settings.
Offset Point
Use this method if you cannot occupy a point directly, but you can
occupy a location close by and provide an azimuth and distance to the
point.
1. Go to the Survey > Data Collection screen.
2. Tap Offset to open the Offset Shots screen.
Note: You can enter the offset data before or after you occupy the
reference point with GPS.
3. Tap Occupy GPS to occupy the GPS reference point. You will be
prompted for a point name to store the reference point. The
receiver is set to static mode and a site occupation begins. When
you are happy with the measurement, tap Accept to return to the
Offset Shots screen.
4. Enter the distance from the GPS reference point to the offset
point. You can enter the distance by hand or you can get it from
the selected conventional instrument by tapping Shoot Laser.
Note: You have to switch to conventional mode to configure the laser
range finder or total station.