Spectra Precision Survey Pro v4.6 Ranger User Manual - Manual (Page 76)

User’s Manual – Conventional Mode
66
Set Up
1. Open the job that was created in the Traverse / Side Shot
Example if it is not already open.
a. From the Main Menu, select File , Open / New to open the
Open / New screen.
b. Tap the file name that was created
earlier listed in the Open Recent Job
list and then tap
. Open . The
coordinates for that job are shown here.
2. Set the job settings. (Only the settings
that affect this example are covered here.)
a. Select Job , Settings from the Main
Menu.
b. Select the Instrument Settings screen
make sure Manual Mode is activated.
c. Select the Surveying Settings screen and confirm that all of
the checkboxes are unchecked.
d. Select the Stakeout Settings screen and make sure the Cut
Sheet Offset Stored
field (at the bottom of the screen) is set to
Actual Offset.
Note: When performing stakeout, you have the option of storing cut
sheet information. This information is stored in the raw data file,
and when using software on a PC, it can be extracted in the form of a
Cut Sheet Report.
e. Tap to save the job settings.
3. Setup your backsight. In this example, we will setup on Point 1
and backsight an object with a known azimuth. When connected
to a total station, you would setup over your occupy point, aim
toward the backsight and zero the horizontal angle in the total
station before continuing.