Twist-lock cable connections – In-Situ Aqua TROLL 100 and 200 Operators Manual User Manual
Page 30
Advertising
Page 30
Aqua
TROLL Operator’s Manual
Section 3: Getting Started
Twist-Lock Cable Connections
1. Remove the protective caps from the Aqua TROLL connector
end and cable connector end.
2. Look at the connectors. Each has a flat side.
Note the pins on the instrument connector (one on each
side) and the slots on the cable connector (one on each side).
Aqua TROLL
(or Cable Connect TROLL Com)
Cable
TIP: Retain the dust
caps to protect the
pins and O-ring from
damage when cable is
not attached.
Pin
Slot
Cable
Flat
Flat
Aqua TROLL
(or Cable Connect TROLL Com)
Advertising
This manual is related to the following products: