In-Situ Aqua TROLL 100 and 200 Operators Manual - Manual (Page 31)

Page 31 Aqua TROLL Operator’s Manual
Section 3: Getting Started
3. Slide back the sleeve on the cable connector.
4. Position the flat edges so they will connect properly, and
insert the instrument connector firmly into the cable
connector.
5. Slide the sleeve on the cable toward the Aqua TROLL until the
pin on the probe fits into the round hole in the slot on the
cable connector.
6. Grasp the textured section of the cable connector in one
hand and the Aqua TROLL in the other. Push and twist firmly
so that the pin on the body connector slides along the slot on
the cable connector and locks securely into the other hole.
Aqua TROLL Cable
Aqua TROLL Cable
Aqua TROLL Cable