In-Situ Aqua TROLL 100 and 200 Operators Manual - Manual (Page 34)

Page 34 Aqua TROLL Operator’s Manual
Section 4: Using Win-Situ
Win-Situ opens and displays the Data area (“Data tab”),
shown below.
2. Check the COM port. The software may ask if you want to
select a COM port. Do one of the following:
4 Answer Yes to the prompt, then check or change the port
in the Comm Settings dialog, and click OK to close
it, or
4
Answer No to bypass this step.
3. Win-Situ asks if you want to connect to the device. If the
Aqua TROLL instrument is connected to your computer as
described in the previous section, answer Yes.
Connect
button
C:\Documents and Settings\ [Login] \My Documents\WinSitu Data
2
3
Data tab
TIP: For direct serial
connection the port
is usually COM 1. This
is the Win-Situ default.
For USB communication, be sure
to select the correct COM port.
TIP: You can turn
off the “Connect
now?” prompt:
Select Prefrences menu > General
Settings, deselect “Prompt for
connect at startup,” click OK. In
this case, connect to the device
by clicking the Connect button
.