In-Situ Aqua TROLL 100 and 200 Operators Manual - Manual (Page 64)

Page 64 Aqua TROLL Operator’s Manual
Field Recalibration Procedure for a Vented Sensor
1. With the Aqua TROLL connected in software, go to the
Sensors tab.
2. Select the pressure sensor and click the Calibrate button
.
3. Select the Pressure parameter and click Calibrate...
4. Select Zero the Level/Pressure sensor. Make sure the device
is dry and exposed to air.
5. Click OK . The software will inform you when the
pressure reading is set to zero.
Section 6: Pressure & Level
2. Select the sensor,
click Calibrate
3. Select Pressure,
click Calibrate...
1. Sensors tab
4. Select Zero the sensor
5. Click OK