In-Situ Aqua TROLL 100 and 200 Operators Manual - Manual (Page 7)

Page 7 Aqua TROLL Operator’s Manual
Section 1: Introduction
Section 3: Getting Started — Attaching cable — Installing and
opening the software
Section 4: Using Win-Situ — Connecting for the first time —
Customizing the Home screen — Setting the clock — Setting a
device site — Calibrating conductivity — Preparing to log data
— Disconnecting
Section 5: The Conductivity Sensor: Description — Calibration —
Available parameters
Section 6: The Pressure (Level) Sensor: The two basic types of
pressure sensors — Factory and field calibration
Section 7: Field Installation — Guidelines and precautions for
long-term deployment of the Aqua TROLL Instrument
Section 8: Connecting for Use with SDI-12, Analog (4-20 mA), and
Modbus Loggers and Controllers
Section 9: Care and Maintenance
Section 10: Troubleshooting
The check mark highlights a tip about a convenient feature of the Aqua TROLL
Instrument.
The exclamation point calls your attention to a requirement or important
action that should not be overlooked.