In-Situ Aqua TROLL 100 and 200 Operators Manual - Manual (Page 12)

Page 12 Aqua TROLL Operator’s Manual
Section 1: Introduction
Outside the U.S.A.
Contact your international In-Situ distributor for repair and service
information.
Guidelines for Cleaning Returned Equipment
Please help us protect the health and safety of our employees by
cleaning and decontaminating equipment that has been subjected
to any potential biological or health hazards, and labeling such
equipment. Unfortunately, we cannot service your equipment
without such notification. Please complete and sign the form on
page 13 (or a similar statement certifying that the equipment has
been cleaned and decontaminated) and send it along to us with
each downhole instrument.
• We recommend a cleaning solution, such as Alconox®, a
glassware cleaning product available from In-Situ (Catalog No.
0029810) and laboratory supply houses.
• DO NOT remove the nose cone. DO NOT use any object to
clean the sensor face.
• Clean the pressure sensor by soaking only in cleaning solution
or clean water.
• Clean all cabling. Remove all foreign matter.
• Clean cable connector(s) with a clean, dry cloth. Do not
submerge.
• Clean the probe body—including the nose cone, cable head,
and protective caps. Remove all foreign matter.
If an instrument
returned for
servicing shows
evidence of having been
deployed in a toxic or hazardous
environment, Customer Service
personnel will require written
proof of decontamination before
they can service the unit.