Badger Meter SRD/SRI Valve Positioners - Manual (Page 34)

Operation with Local Keys
Operation with LCD
• Press the () key to enter the Menu mode Menu 1
appears
• Press the (+) or (–) key to select a Menu item Each press
of the key moves one menu item forward (or back)
• Press the () key to confirm your selection and enter the
Parameter change mode for the selected item
• Press the () key again to exit the Menu mode
◊ If device remains in menu mode it still is OUT OF
SERVICE and AUTOSTART has to be initiated
◊ If the instrument is IN OPERATION, the display with the
valve position appears
◊ If a menu was selected and no further keys are
pressed thereafter, the SRD switches automatically
back to operation after some minutes
Operation with LED
• Press the () key to enter the Menu The red LED flashes
alternately with the green LED1, which indicates the
Menu item 1
• Press the (+) or (–) key to select a Menu item Each press
of the key moves one menu item forward (or back) The
flashing green LEDs indicate the selected menu item
LED test before configuration: Move from menu item 1 to
4 and inspect that each LED lights
• Press the () key to confirm your selection and enter the
Parameter change mode for the selected item
The red LED goes off and the remaining green LED
indicates the parameter or state to be set 1)
To set a parameter, see the Parameter table
• Press the () key again to exit the Menu Red and green
LEDs extinguish when device is IN SERVICE
◊ If device remains in menu mode it still is OUT OF
SERVICE and AUTOSTART has to be initiated
◊ If a menu was selected and no further keys are
pressed thereafter, the SRD switches automatically
back to operation after some minutes
1) Exception in Menu 6 (and at PROFIBUS Menu 10) No parameter indicated at first, but
flashing rhythm with long green and short red phases This points to a sub-menu Then
entry into parameter selection as described
Page 34
Startup
August 2014 POS-UM-00009-EN-02