NORD Drivesystems BU0020 - Manual (Page 15)

2 Modules
BU 0020 GB-2612 15
2.1.1 SK TU2 Profibus Module, Overview
The Profibus DP communication modules SK TU3-PBR and SK TU3-PBR-24V are used to connect
drive units of the SK 500E series to higher level automation systems via Profibus DP.
Module Description Data
Profibus module
SK TU3-PBR
This option enables control of the SK 5xxE via the
Profibus DP interface with the performance level DP-V0 Baud rate: up to 1.5
MBaud
Connector: Sub-D9
Part No. 275900030
Profibus module
SK TU3-PBR-24V
This option enables control of the SK 5xxE via the
Profibus DP interface with the performance level DP-V0 Baud rate: up to 12
MBaud
Connector: Sub-D9
External 24V voltage
supply, 2 pin connector
Part No. 275900160
Table 2: SK TU3-PBR, Overview of Technology Units
Note
If several SK 500E frequency inverters are installed immediately adjacent to each other
in a control cabinet, only SUB-D9 Profibus bus connectors with a 45° or 0° cable outlet
should be used to connect the Profibus technology unit.
If necessary, in case of any vibration and contact problems, the Profibus cables should
be fixed by means of SK 8 shield terminals and a shield bracket in the control cabinet.
Note
The cable shield must be connected to the functional earth
1
(usually the
electrically conducting mounting plate) in order to avoid EMC interference in the
device.
To achieve this, in the Profibus connector the shield must be connected to a large area
of the D-SUB connector and the functional earth.
Pos: 27 /Anleitungen/Bussysteme/2. Baugruppen/Profibus [BU0020]Profibus Modul, SK TU3-PBR @ 1\mod_1335252903589_388.docx @ 21541 @ 3 @ 1
1 In systems, electrical equipment is usually connected to a functional earth. This serves as a means to dissipate leakage and
interference currents in order to ensure EMC characteristics and must therefore be implemented according to high frequency
technology aspects.