HP XP Continuous Access Software - Manual (Page 105)

2. Display the DKC Operation pane (see Displaying the DKC Operation pane ).
3. In the Switch Display box, select Port. The tree displays channel adapters in the local array and
port attributes.
4. Do one of the following:
• Select a channel adapter from the tree.
• Select a port attribute (that is, target, RCU target, or initiator) from the tree.
5. Right-click the port you want to configure.
6. Select the port type (that is, initiator, RCU target, or target).
The right-most column of the list displays Modified to indicate you are modifying the port attribute.
The Preset list displays the changes you made. These changes are not applied to the array yet.
7. In the Preset list, check the settings.
• To change the port attribute, right-click the port from the upper-right list, and select the new
attribute.
• To cancel a change in the port attribute, right-click the port in the Preset list, and click Cancel.
CAUTION:
Read and follow the important cautions above before applying port attribute changes.
8. Click Apply to apply port attribute changes to the array.
Associating primary and remote arrays and configuring
logical paths (Add DKC)
Use the Add DKC pane to associate the primary and secondary arrays and establish logical paths
between the two arrays. Logical paths connect the primary and secondary arrays. The primary and
secondary arrays use logical paths to communicate with each other.
One primary array can be associated with up to 64 secondary arrays. Up to eight logical paths can
be configured (in each direction) between one primary array and one secondary array. Therefore, one
primary array can have up to 512 logical paths to secondary arrays.
To associate the primary and secondary arrays and configure logical paths between the two arrays, the
primary and secondary array administrators must perform the following procedure:
1. Ensure that the remote copy connections and ports are properly configured. Also, obtain the remote
array's serial number.
NOTE:
To get the remote array's serial number, ask the remote array's administrator. The serial
number is displayed in the Command View XP or XP Remote Web Console main pane
when logging into the array.
2. Ensure that Command View XP or XP Remote Web Console is in Modify mode. For more information,
see the HP StorageWorks Command View XP user guide for XP Disk Arrays or the HP StorageWorks
XP Remote Web Console user guide for XP12000/XP10000/SVS200.
3. Display the DKC Operation pane (see Displaying the DKC Operation pane ).
4. In the Switch Display box, select DKC.
5. Select Subsystem from the tree.
6. Right-click the upper-right list, and select DKC Operations and Add DKC. The Add DKC pane appears.
7. In the Add DKC pane, enter the following:
Continuous Access XP Journal user guide 105