HP XP Continuous Access Software - Manual (Page 106)

• Remote array's serial number.
• Remote array's controller ID.
NOTE:
The controller ID for an XP12000/XP10000 is 4.
• Path group ID. The path group ID is within the range of 1-FF (hexadecimal). Up to 64 path
group IDs can be registered per array.
NOTE:
In the current version, the path group IDs always take the default values and cannot be changed.
8. In the Add DKC pane, select a primary and remote array port to configure a logical path.
9. Click Option.
10. In the DKC Option pane, configure the logical path and array options. For more information, see
Changing options for logical paths and arrays .
11. Click Set to close the DKC Option pane.
12. In the Preset list, check the settings you made.
• To modify a setting, right-click the setting from the Preset list, and select Modify. A pane
appears where you can modify the setting.
• To cancel a setting, right-click the setting in the Preset list, and select Cancel.
13. Click Apply to apply the settings.
NOTE:
If an error occurs, the right-most column of the Preset list displays the error code. To view
detailed information about the error, right-click the error code, and select Error Detail. An
error message appears providing detailed information about the error.
106 Configuring arrays and logical paths