Cascading configurations), Transferring business tasks from – HP XP Continuous Access Software User Manual
Page 86
Figure 34 Changing to a 3DC multi-target configuration after recovering from primary
site failures
Trans. business tasks from CA XP sec. sites to pri. sites (in 3DC casc. configs.)
If you follow the instructions in
Recovering from primary site failures
and the system changes to a 3DC
cascading configuration, you can transfer your business tasks back to the primary site after removing
failures from the primary site and other locations.
To transfer your business tasks back to the primary sites:
1.
Stop your business tasks at the Continuous Access XP Synchronous secondary site.
2.
Use RAID Manager XP to execute the horctakeover command on the Continuous Access XP
Synchronous pair. The system configuration returns to a 3DC multi-target configuration.
3.
Use the primary volume at the primary site to resume your business tasks.
86
Continuous Access XP Journal operations requirements and restrictions