HP XP Continuous Access Software - Manual (Page 123)

To register journal volumes, the primary and secondary array administrators must perform the following
procedure:
1. Ensure that Command View XP or XP Remote Web Console is in Modify mode. For more information,
see the HP StorageWorks Command View XP user guide for XP Disk Arrays or the HP StorageWorks
XP Remote Web Console user guide for XP12000/XP10000/SVS200.
2. Display the Journal Operation pane ( Displaying the Journal Operation pane ).
3. In the tree of the Journal Operation pane, do one of the following:
• To register new volumes to a journal group in which journal groups are already registered,
select the journal group from below Registered.
CAUTION:
You can register volumes only when the journal group's attribute is Initial or the journal group's
status is Active, Stop, Hold , or Hold(Failure).
• To register volumes to a journal group in which journal groups have not been registered,
select the journal group from below Free.
NOTE:
You cannot select more than one journal group.
4. Do one of the following:
• In the tree, right-click the selected journal group, and select Edit JNL Volumes.
• In the upper-right list, right-click the desired journal group, and select Edit JNL Volumes.
5. In the Free Volumes list of the Edit JNL Volumes pane ( Figure 50 ), select the volumes you want
to register.
In the Free Volumes list, one row represents one volume. If you cannot find the volumes you want
to register, do any of the following:
• Select PG, enter a parity group number in the text boxes to the right, and click Show. The list
displays volumes in the specified parity group. Select the volumes you want to register.
• To register external LUs, select PG(Ext.), enter a parity group number in the text boxes to
the right, and click Show. The list displays volumes in the specified parity group. Select
the volumes you want to register.
NOTE:
Parity group numbers for external LUs start with E, but you do not need to enter E in the text
boxes. For example, to specify the parity group number E1-2, you only need to enter 1 and
2 in the text boxes.
• Select CU, and select a CU number from the list to the right. The list displays volumes in the
specified CU. Select the volumes you want to register.
NOTE:
In the current version, the Free Volume list only displays OPEN-V volumes.
6. Click Add. The JNL Volumes list displays the volumes you want to register. The Operation column of
the list displays Add.
NOTE:
One journal group can contain only volumes belonging to the same CLPR.
Continuous Access XP Journal user guide 123