HP XP Continuous Access Software - Manual (Page 150)

12. Click Set to close the Paircreate pane.
13. In the Preset list on the Pair Operation pane, check the settings you made.
• To modify a setting, right-click the setting, and select Modify.
• To cancel a setting, right-click the setting, and select Cancel.
14. Click Apply to start the pair creation and initial copy operations.
NOTE:
If an error occurs, the right-most column of the Preset list displays the error code. To view
detailed information about the error, right-click the error code, and select Error Detail. An
error message appears providing detailed information about the error.
15. In the list on the Pair Operations pane, verify that the status of the pair is correct
If you selected Entire or None in step 10, the pair status is COPY. If you selected Delta, the pair
status is HOLD.
16. To monitor the progress of the paircreate operations, click Refresh to update the information in the
list or use the Pairdisplay pane ( Figure 61 ) to monitor the detailed status of each pair.
Figure 60 Paircreate pane
•
P-VOL: Primary data volume. The numbers indicate the primary data volume's port number,
G-ID, and LUN. The numbers in parentheses are the CU and LDEV numbers. The G-ID is a
group number for a host group or iSCSI target.
150 Performing Continuous Access XP Journal pair operations