HP XP Continuous Access Software - Manual (Page 160)

NOTE:
If an error occurs, the right-most column of the Preset list displays the error code. To view
detailed information about the error, right-click the error code, and select Error Detail. An
error message appears providing detailed information about the error.
11. In the list on the Pair Operations pane, verify that the pairs were successfully restored.
• If the pair was successfully restored, the pair status is COPY or PAIR.
• If the delta resync operation was successfully performed, the pair status is COPY or PAIR.
• If the operation to change pair status was successfully performed, the pair status changes
to HOLD.
12. To monitor the progress of restoring pairs, click Refresh to update the information in the list or use
the Pairdisplay pane (see Displaying detailed information about journal groups ) to monitor the
detailed status of each pair.
Figure 64 Pairresync pane
• Range: Restore range. If you select two or more pairs in the same consistency group, the default
is LU. Otherwise, the default is Group. The default setting is Group when the pair status is HOLD
or HLDE. In that case, you cannot change the default setting.
• LU: Only the specified pairs are restored.
• Group: All pairs in the same consistency groups as the selected pairs are restored.
NOTE:
If the following two conditions are satisfied and you click Apply, a warning message appears
and processing cannot continue:
• The Preset list contains two or more pairs belonging to the same consistency group.
• The Range column displays Group for at least one of the above pairs.
To continue processing, do one of the following:
• Ensure that the Range column displays LU for all pairs in the same consistency group.
• In the Preset list, select all but one pair in the same consistency group, right click the selected
pairs, and select Delete.
• Priority: Specify the desired priority (1-256) (scheduling order) for the pair-restoring operations.
NOTE:
If Range is Group, you cannot change Priority.
• DKC: Array.
• Resync Mode: Processing after recovery of the pairs.
160 Performing Continuous Access XP Journal pair operations