Software reset command – MagTek IntelliStripe 320 99875168 User Manual
Page 18
Advertising
IntelliStripe 320 Command Reference
12
SOFTWARE RESET COMMAND
Command ID: 80 (Hex)
Description:
This command is used to reset the device. This will put the device in its power up state. The
device should be allowed time to power up before trying to communicate with the device. The
maximum time it would take the device to reset would be 5 seconds.
Request Message Data: None
Response Message Data: None
Response Message Result Codes:
Success = 00 (Hex)
The command completed successfully.
Example Request:
Field MTYP
APPL
CMND
RC
Byte 1
2
3
4
Value (Hex)
00
00
80
00
Example Response:
Field MTYP
APPL
CMND
RC
Byte 1
2
3
4
Value (Hex)
40
00
80
00
Advertising