Select connector command – MagTek IntelliStripe 320 99875168 User Manual
Page 57
Section 5. Smart Card Application
51
SELECT CONNECTOR COMMAND
Command ID: 86 (Hex)
Description:
The IFD supports up to 8 connectors numbered 0-7. Connector 0 is the User Connector, and is
used by default when the system starts. Connectors 1-7 may be used for Secure Access Modules
(SAMs) as part of application infrastructure.
This command allows the application to select the connector to be used in commands that follow.
The connector assignment stays in effect until it is changed by another Select Connector
Command or the device is power cycled.
Request Message Data:
Byte Field
Description
1 Connector
Number
The
number, in Hex, to be selected
Response Message Data: None
Response Message Result Codes
Code
Meaning
00
Success
Example Request:
Field MTYP
APPL
CMND
RC
DATA
Byte
1 2 3 4 5
Value
(Hex)
00 02 86 00 02
Example Response:
Field MTYP
APPL
CMND
RC
Byte
1 2 3 4
Value
(Hex)
40 02 86 00