MagTek IntelliStripe 320 99875168 - Manual (Page 47)

Section 5. Smart Card Application
41
POWER UP COMMAND
Command ID: 80 (Hex)
Description:
This command is used to power up a smart card in the currently selected connector. If it is
available, the ATR from the card is returned.
Request Message Data: None
Response Message Data:
Byte Field
Description
1-n ATR Answer to Reset as received from the card.
Response Message Result Codes
Code (Hex) Meaning
00 Success, the command completed without problems
01 Failure, the command was not able to complete, see CondRpt property for
details. See below for Error/Warning Conditions Template construction.
02 Warning, the command completed, but some problems arose, see CondRpt
property for details. See below for Error/Warning Conditions Template
construction.
Error/Warning Conditions Template Construction – Microprocessor Cards Only
The Error/Warning Condition Templates (Power Up Error Conditions Template and
Power Up Warning Conditions Template properties respectively) have the following
structure:
Byte Bit Meaning
0 0 Unrecoverable Receive Error. This condition indicates a receive error that
could not be corrected by the permitted number of parity correction retries.
0 1 Timeout On Receive. This condition indicates a receive timeout.
0 2 Specific f/d ratio required but not supported. This condition arises when a
card sends the TA2 byte and the values of FI and DI in TA1 require an f/d
ratio the IFD can not support. The IFD supports f/d ratios as low as 31,
which is equivalent to an I/O rate of 129kbs.
0 3 Specific protocol required but not supported. The card has required a
protocol which the IFD does not support. The IFD supports T=0 and T=1.
0 4 Requested f/d ratio not supported, may be negotiable. The card has
requested an f/d ratio that is not supported, but it has indicated that it may
negotiate via Warm Reset.
0 5 Requested protocol not supported, may be negotiable. The card has
requested a protocol that is not supported, but it has indicated that it may
negotiate via Warm Reset.