Consume card command – MagTek IntelliStripe 320 99875168 User Manual
Page 70
IntelliStripe 320 Command Reference
64
CONSUME CARD COMMAND
Command ID: 80 (Hex)
Description:
This command attempts to consume a card into the transport to a position where smart card
communications can occur and magnetic stripe reading is complete. A card must be present at
the front (insertion) end of the transport when this command is executed in order for it to
succeed. The reader will not attempt to consume a card if a card is already present in the
transport. If the consume attempt is successful and the card is standard sized, the Rear Card
Present indicator and the Middle Card Present indicator will be set to show that the card is
completely consumed. If the Middle Card Present indicator is set and the consume attempt is
unsuccessful then the card should be ejected.
Request Message Data: None
Response Message Data: None
Response Message Result Codes:
Success = 00 (Hex)
The command completed successfully.
Transporting Failed = 80 (Hex)
The transport operation failed to complete successfully.
Transport Busy = 81 (Hex)
The command failed because the transport is busy transporting a card. This could
occur if the transport is set to Auto Consume.
Transport Cooling = 82 (Hex)
The command failed because the transport is cooling. This occurs if the transport
is temporarily disabled due to too many stalls. See the transport indicators
property for more details.
Example Request:
Field MTYP
APPL
CMND
RC
Byte 1
2
3
4
Value (Hex)
00
82
80
00
Example Response:
Field MTYP
APPL
CMND
RC
Byte 1
2
3
4
Value (Hex)
40
82
80
00