MagTek IntelliStripe 320 99875168 - Manual (Page 19)

13
SECTION 4. MAGNETIC STRIPE APPLICATION
Application ID: 01 (Hex)
Description:
This application deals with decoding and presenting magnetic stripe card data. This application
works closely with the transport application, which deals with card transportation and magnetic
stripe data acquisition. The transport application must be used to acquire magnetic stripe data
before any data is available to decode and present by the magnetic stripe application.
GET/SET/SAVE PROPERTY COMMANDS
Get Property Command ID: 00 (Hex)
Set Property Command ID: 01 (Hex)
Save Property Command ID: 02 (Hex)
Description:
These commands are used to get, set and save the value of application properties. Details of
these commands are described in the Generic command section of this document. The following
describes each property this application supports.