MagTek IntelliStripe 320 99875168 - Manual (Page 61)

55
SECTION 7. TRANSPORT APPLICATION
Application ID: 82 (Hex)
Description:
This application deals with card transportation and magnetic stripe data acquisition. This
application works closely with the Magnetic Stripe application. The Magnetic Stripe application
deals with decoding and presenting magnetic stripe card data.
GET/SET/SAVE PROPERTY COMMANDS
Get Property Command ID: 00 (Hex)
Set Property Command ID: 01 (Hex)
Save Property Command ID: 02 (Hex)
Description:
These commands are used to get, set and save the value of application properties. Details of
these commands are described in the Generic command section of this document. The following
describes each property this application supports.
INDICATORS PROPERTY
Property ID: 00 (Hex)
Property Type: Dword
Power Up/Reset Value: Dependent on indicator states
Get/Set/Save support: Get
Description:
This property is used to get the transport indicators. These indicators are used to determine the
state of the transport and the location of any cards present in the transport.
Values:
The bits are identified by numbering the least significant bit 0 and the most significant bit 31.