MagTek IntelliStripe 320 99875168 - Manual (Page 72)

IntelliStripe 320 Command Reference
66
When the eject type is set to blind (2), the reader will attempt to eject the card without using any
sensors. This option can be used to attempt to eject a card that has jammed in the unit or that is
in the unit but is invisible to the sensors. This option will simply run the motor in the eject
direction for a fixed time period that would normally drive a card out of the device. Since no
sensors are used for this option the card may be ejected past the motor driver roller and
depending on the bezel used, it may eject completely out of the unit.
Response Message Data: None
Response Message Result Codes:
Success = 00 (Hex)
The command completed successfully.
Transporting Failed = 80 (Hex)
The transport operation failed to complete successfully.
Transport Busy = 81 (Hex)
The command failed because the transport is busy transporting a card. This could
occur if the transport is set to Auto Consume.
Transport Cooling = 82 (Hex)
The command failed because the transport is cooling. This occurs if the transport
is temporarily disabled due to too many stalls or blind ejects. See the transport
indicators property for more details.
Example Request:
Field MTYP APPL CMND RC
Byte 1 2 3 4
Value (Hex) 00 82 81 00
Example Response:
Field MTYP APPL CMND RC
Byte 1 2 3 4
Value (Hex) 40 82 81 00