MagTek IntelliStripe 320 99875168 - Manual (Page 65)

Section 7. Transport Application
59
NOTIFY INDICATOR CHANGE 1 TO 0 PROPERTY
Property ID: 02 (Hex)
Property Type: Dword
Power Up/Reset Value: 0
Get/Set/Save support: All
Description:
This property is used control notification messages sent in response to a transport indicator
changing from a 1 to a 0 state. If the bit corresponding to an indicator is set, then a notification
message will be sent from the device to the host in response to that indicator changing from a 1
to a 0 state. The notification message will have the same syntax as the get property command
response of the indicator property. The only difference is that the message header will contain a
notification message type instead of a response message type. If more than one indicator
changes state at the same time, only one notification message will be sent that contains the state
of all the indicators.
Values:
The bits are identified by numbering the least significant bit 0 and the most significant bit 31.
Bits Indicator Description
0 Front Card
Present
If set to 1, a notification message will be sent in response to a
1 to 0 transition of the front card present indicator. If cleared
to 0, no notification will be sent.
1-2 RFU (0) Reserved for future use (Must be zero)
3 Auto Transporting If set to 1, a notification message will be sent in response to a
1 to 0 transition of the auto transporting indicator. If cleared
to 0, no notification will be sent.
4 – 6 RFU Reserved for future use
7 *MagnePrint Noise If set to 1 a notification message will be sent in response to a
1 to 0 transition of the MagnePrint™ noise indicator. If
cleared to 0, no notification will be sent.
8-31 RFU Reserved for future use
*Available only on units with MagnePrint feature
Example Set Property Request:
Field MTYP APPL CMND RC PTYP PID PVAL
Byte 1 2 3 4 5 6 7 - 10
Value (Hex) 00 82 01 00 01 02 01 00 00 00 (Front Card
Present)
Example Set Property Response:
Field MTYP APPL CMND RC
Byte 1 2 3 4
Value (Hex) 40 82 01 00