MagTek IntelliStripe 320 99875168 - Manual (Page 38)

IntelliStripe 320 Command Reference
Power Up Warning
Conditions
Template 1C Binary 4 (Hex)*
70 d0 47
00
Get/Set Used to define which conditions shall be considered warnings when
powering up the card. The options in this bit-map are defined in the
description of the Power Up command.
Power Up Warm
Reset Conditions
Filter Template 1D Binary 4 (Hex)*
00 00 00
00
Get/Set Used in combination with an EMV Cold / Warm Power Up sequence.
When a warm reset is necessary, the Warning Conditions Template is
ANDed with the inverse of the Warm Reset Conditions Filter Template,
then the resulting Warning Conditions Template is copied to the Error
Conditions Template just before the Warm Reset occurs. The effect is to
allow conditions which were considered warnings during the Cold Reset
to be ignored during the Warm Reset. See the description of the Power
Up command for more information.
PPS Allowed 1E Boolean 1 TRUE* Get/Set If a card sends an ATR allowing more than one protocol and/or speed,
the value of this property indicates whether a PPS sequence should be
performed. If this property is set to TRUE, a PPS will be performed,
otherwise it will not be sent.
Protocol Selection
Allowed 1F Boolean 1 TRUE Get/Set This property indicates if a PPS sequence is allowed to select a different
protocol. If it is set TRUE and a PPS sequence is performed, the
sequence will not attempt to select a different protocol.
Speed Selection
Allowed 20 Boolean 1 TRUE Get/Set This property indicates if a PPS sequence is allowed to select a different
speed. If it is set to TRUE and a PPS sequence is performed, the
sequence will not attempt to select a different speed.
Force PPS1
Transmission 21 Boolean 1 FALSE Get/Set This property is only referenced when performing a PPS sequence. If it is
TRUE, the PPS sequence will always include a PPS1 byte. If it is FALSE
a PPS1 byte would only be included if a speed change were required.
This property exists to allow the user to tailor the PPS sequence for cards
with special requirements. Unless your card is having problems with
PPS, we recommend you leave this property FALSE.
Reset Delay 22 Dword 1 2* Get/Set Time to hold RST low in either a Cold or Warm Reset sequence. The
units are increments of 200 card clocks. The default value of 2 yields 400
clocks per ISO 7816-3(1997). In EMV Mode this property is set to 205,
yielding 41,000 clocks.
Abort on Parity
Error in ATR 23 Boolean 1 FALSE* Get/Set If this property is TRUE and a parity error is detected in the ATR, the card
is powered down immediately and the Power Up request fails. If it is
FALSE and a parity error occurs in the ATR, the IFD will request the byte
from the card again.
32