T=1 error / warning condition templates – MagTek IntelliStripe 320 99875168 User Manual
Page 51
Section 5. Smart Card Application
45
T=1 ERROR / WARNING CONDITION TEMPLATES
Byte Bit Meaning
0
0
Timeout On Receive. This condition indicates a receive timeout.
0
1
Parity Error in received data. This condition indicates that there was
a parity error in a message received from the card.
0
2
I/O errors in a message received from the card. These errors could
be Length, EDC, or an invalid PCB.
0
3
The card rejected a message with the indication: Error Free
0
4
The card rejected a message with the indication: EDC Error
0
5
The card rejected a message with the indication: Other Error
0
6
Reserved for Future Use.
0
7
Card Aborted a chain being sent by the IFD.
1
0
Card Aborted a chain being sent by the Card.
1
1
Input Buffer Overflow. The card tried to send a chain of messages
that is larger than the available buffer space.
1
2
The card sent an I-Block message (or chain) with no content in the
INF field.
1
3
The card was sending chained data when a Resynch sequence was
required, the chained data from the card was lost.
1
4
The IFD was not sending a chained message to the card and the
card sent an R-Block requesting a message other than the one we
are trying to send. This is a protocol error on the part of the card.
1
5
Invalid Sequence Number in an I-Block received from a card.
1
6
The IFD was sending a chained message to the card and the card
sent an R-Block requesting a message other than the one we are
trying to send.
1
7
Reserved for Future Use
2
0
Invalid S-Block Response Type from the card. An S-Block was sent
to the card and it responded with an S-Block of the wrong type.
2
1
Invalid S-Block Response Data from the card. An S-Block was sent
to the card and it responded with an S-Block with an invalid INF field.
2
2
Invalid S-Block Request Type from card. The card sent an S-Block
Request with an invalid Type.
2
3
Invalid S-Block Request Data from card. The card sent an S-Block
Request with an invalid INF field.
2
4
Resynch needed, completed successfully.
2
5
Resynch needed, but not performed because it is disables (property
Initial Resynch Allowed or Current Session Resynch Allowed).
2
6
Resynch not attempted, protocol had not yet started.
2
7
Reserved for Future Use
3 0
Resynch
failed.
3
1
S-Block exchange failed, no more retries.
3
2-7 Reserved for Future Use