MagTek IntelliStripe 320 99875168 - Manual (Page 68)

IntelliStripe 320 Command Reference
62
EJECT MIDDLE SENSOR TO MOTOR OFF DELAY PROPERTY
Property ID: 05 (Hex)
Property Type: Dword
Power Up/Reset Value: 51 (.5 inches)
Get/Set/Save support: All
Description:
This property is used to control the distance that the card ejects past the middle sensor
when using the card eject command with the normal eject type option. The units of this
property is milli-seconds. Once the card unblocks the middle sensor during card ejection,
a timer will start counting down a number of milli-seconds equal to the value of this
property. Once this timer hits zero the motor will be shut off. To convert the distance
you desire the card to stop past the middle sensor to milli-seconds, multiple the desired
number of inches by 100. The card moves at about 1 inch per 100ms. The value of this
property can range from 0 to 255ms.
Example Set Property Request:
Field MTYP APPL CMND RC PTYP PID
Byte 1 2 3 4 5 6
Value (Hex) 00 82 01 00 01 05
Field PVAL
Byte
7 - 10
Value (Hex) 33 00 00 00 (51ms or .5
inches)
Example Set Property Response:
Field MTYP APPL CMND RC
Byte 1 2 3 4
Value (Hex) 40 82 01 00