Allied Telesis AT-S95 CLI (AT-8000GS Series) - Manual (Page 112)

Page 112
Allied Telesis
AT-8000GS Command Line Interface User’s Guide
show interfaces configuration
The show interfaces configuration Privileged EXEC mode command displays the configuration for all
configured interfaces.
Syntax
show interfaces configuration [ethernet interface | port-channel port-channel-number]
Parameters
•
interface — Valid Ethernet port. (Full syntax: unit/port)
• port-channel-number — Valid port-channel number.
Default Configuration
This command has no default configuration.
Command Modes
Privileged EXEC mode
User Guidelines
There are no user guidelines for this command.
Example
The following example displays the configuration of all configured interfaces:
g16 100M-Copper Enabled --
g17 100M-Copper Enabled --
g18 100M-Copper Enabled --
g19 100M-Copper Enabled --
g20 100M-Copper Enabled --
console# show interfaces configuration
Port Type Duplex Speed Neg Flow
Ctrl
Link
State
Back
Pressure
Mdix
Mode
---- ----------- ------ ----- ------- ---- ----- -------- ----
g1 100M-Copper Full 100 Enabled Off Up Disabled Auto
g2 100M-Copper Full 100 Enabled Off Up Disabled Auto
g3 100M-Copper Full 100 Enabled Off Up Disabled Auto
g4 100M-Copper Full 100 Enabled Off Up Disabled Auto
g5 100M-Copper Full 100 Enabled Off Up Disabled Auto
g6 100M-Copper Full 100 Enabled Off Up Disabled Auto
g7 100M-Copper Full 100 Enabled Off Up Disabled Auto
g8 100M-Copper Full 100 Enabled Off Up Disabled Auto