Allied Telesis AT-S95 CLI (AT-8000GS Series) - Manual (Page 207)

Power over Ethernet Commands
Page 207
Default Configuration
This command has no default configuration.
Command Mode
Interface Configuration (Ethernet) mode
User Guidelines
There are no user guidelines for this command.
Example
The following example configures a description to an IP-phone to a powered device connected to Ethernet
interface 1/g16.
power inline priority
The power inline priority Interface Configuration (Ethernet) mode command configures the inline power
management priority of the interface. Use the no form of this command to return to the default configuration.
Syntax
power inline priority {critical | high | low}
no power inline priority
Parameters
•
critical — Indicates that operating the powered device is critical.
• high — Indicates that operating the powered device has high priority.
• low—Indicates that operating the powered device has low priority.
Default Configuration
The default setting is low priority.
Command Mode
Interface Configuration (Ethernet) mode
User Guidelines
There are no user guidelines for this command.
Example
The following example configures the device connected to Ethernet interface 1/g16 as a high-priority powered
device.
console(config)# interface ethernet 1/g16
console(config-if)# power inline powered-device IP-phone
console(config)# interface ethernet 1/g16
console(config-if)# power inline priority high