Show system defaults – Allied Telesis AT-S95 CLI (AT-8000GS Series) User Manual
Page 332
Page 332
Allied Telesis
AT-8000GS Command Line Interface User’s Guide
show system defaults
The show system defaults User EXEC mode command displays specified system defaults.
Syntax
show system defaults [section]
Parameters
•
section — Display information only for specific session. Available values are: management, 802.1x, port,
fdb, port-mirroring, spanning-tree, vlan, ip-addressing, network-security and qos-acl.
Default Configuration
This command has no default configuration.
Command Mode
User EXEC mode
User Guidelines
There are no user guidelines for this command.
Unit
SW version
Boot version
HW version
----
----------
------------
----------
1
v1.1.0.29
1.0.1.06 01.00.00
2
v1.1.0.29
1.0.1.06
01.00.00
3
v1.1.0.29
1.0.1.06
01.00.00
4
v1.1.0.29
1.0.1.06
01.00.00
5
v1.1.0.29
1.0.1.06
01.00.00
6
v1.1.0.29
1.0.1.06
01.00.00
console#