Allied Telesis AT-S95 CLI (AT-8000GS Series) - Manual (Page 178)

Page 178
Allied Telesis
AT-8000GS Command Line Interface User’s Guide
Syntax
lldp optional-tlv tlv1 [tlv2 … tlv5]
no lldp optional-tlv
Parameters
•
tlv — Specifies the TLV that should be included. Available optional TLVs are: port-desc, sys-name,
sys-desc, sys-cap and 802.3-mac-phy.
Default Configuration
No optional TLV is transmitted.
Command Mode
Interface Configuration (Ethernet) mode.
User Guidelines
There are no user guidelines for this command.
Example
The following example specifies which optional TLV (2)s from the basic set should be transmitted.
lldp management-address
The lldp management-address Interface Configuration mode command specifies the management address that
is advertised from an interface. Use the no form of this command to revert to the default setting.
Syntax
lldp management-address {ip-address | none}
no management-address
Parameters
•
ip-address — Specifies the management address to advertise.
• none — Specifies not to advertise any address.
Default Configuration
No IP address is advertised.
Command Mode
Interface Configuration (Ethernet) mode.
User Guidelines
•
Each port can advertise one IP address.
• Only static IP addresss can be advertised.
console(config)# interface ethernet g5
console(config-if)# lldp optional-tlv sys-name