Allied Telesis AT-S95 CLI (AT-8000GS Series) - Manual (Page 325)

System Management Commands
Page 325
Syntax
stack reload [unit unit]
Parameters
•
unit — Number of the unit to be reloaded (Range: 1 - 6)
Default Configuration
All units are reloaded.
Command Modes
Privileged EXEC mode
User Guidelines
This command is not relevant to standalone devices.
If no unit is specified, all units are reloaded.
Example
The following example reloads Unit 2 of the stack.
stack change unit-id
The stack change unit-id Global Configuration mode command is used to change the Unit ID of a specific unit.
Syntax
stack change unit-id unit-number to new-unit-number
Parameters
•
unit-number — Specifies the current number of the unit. (Range: 1 - 6)
• new-unit-number — Specifies the new number of the unit. (Range: 1 - 6)
Default Configuration
The automatically configured unit number is assigned.
Command Modes
Global Configuration mode
User Guidelines
This command is not relevant to standalone devices.
The command takes effect only after resetting the device.
console(config)# stack reload unit 2