Allied Telesis AT-S95 CLI (AT-8000GS Series) - Manual (Page 118)

Page 118
Allied Telesis
AT-8000GS Command Line Interface User’s Guide
User Guidelines
There are no user guidelines for this command.
Example
port storm-control include-multicast (IC)
The port storm-control include-multicast Interface Configuration (Ethernet) mode command counts Multicast
packets in Broadcast storm control. Use the no form of this command to disable counting Multicast packets.
Syntax
port storm-control include-multicast
no port storm-control include-multicast
Parameters
This command has no arguments or keywords.
Default Configuration
Multicast packets are not counted.
Command Modes
Interface Configuration (Ethernet) mode
User Guidelines
This command is relevant to FE devices only.
To control Multicasts storms, use the port storm-control broadcast enable and port storm-control broadcast
rate commands.
Example
The following example enables counting Broadcast and Multicast packets on Ethernet port 2/g3.
port storm-control broadcast enable
The port storm-control broadcast enable Interface Configuration (Ethernet) mode command enables Broadcast
storm control. Use the no form of this command to disable Broadcast storm control.
Syntax
port storm-control broadcast enable
no port storm-control broadcast enable
Console# show system flowcontrol
console(config)# interface ethernet 2/g3
console(config-if)# port storm-control include-multicast