Allied Telesis AT-S95 CLI (AT-8000GS Series) - Manual (Page 215)

QoS Commands
Page 215
Parameters
•
rate — Maximum kilobits per second of ingress traffic on a port. (Range: 3500 - 1000000).
Default Configuration
1000 Kbits/Sec
Command Mode
Interface Configuration (Ethernet) mode
User Guidelines
The command can be enabled on a specific port only if port storm-control Broadcast enable interface
configuration command is not enabled on that port.
Example
The following example limits the rate of the incoming traffic to 62.
traffic-shape
The traffic-shape Interface Configuration mode command sets a shaper on an egress interface. Use the no form
of this command to disable the shaper.
Syntax
traffic-shape committed-rate [committed-burst]
no traffic-shape
Parameters
•
committed-rate — The average traffic rate (CIR) in bits per second (bps). (Range: 64 -10000000.)
• committed-burst — The excess burst size (CBS) in bytes. (Range: 4096-16769020.)
Default Configuration
No shape is defined.
Command Mode
Interface Configuration mode
User Guidelines
There are no user guidelines for this command.
Example
The following example configures a shaper on port g1.
Console(config-if)# rate-limit 62
console(config-if)# traffic-shape 50000