Allied Telesis AT-S95 CLI (AT-8000GS Series) - Manual (Page 132)

Page 132
Allied Telesis
AT-8000GS Command Line Interface User’s Guide
User Guidelines
If an IP address is not configured by this command, and no IP address is configured for the IGMP querier VLAN
interface, the querier is disabled.
Example
.The following example configures the source IP address that the IGMP Snooping querier uses.
ip igmp snooping querier version
The ip igmp snooping querier version Interface Configuration mode command configures the IGMP version of
an IGMP querier on a specific VLAN. Use the no form of this command to return to default.
Syntax
ip igmp snooping querier version {2 | 3}
no ip igmp snooping querier version
Parameters
•
2 — Specifies that the IGMP version is IGMPv2.
• 3 — Specifies that the IGMP version is IGMPv3.
Default Configuration
IGMPv3
Command Mode
Interface Configuration (VLAN) mode
User Guidelines
If the IGMP querier is configured to IGMPv3, the querier trys to work in IGMPv3. In case the hosts do not support
IGMPv3, the querier version is downgraded.
If the IGMP querier is configured to IGMPv2, the querier trys to work in IGMPv2. It can be downgraded
automatically to IGMPv1, but never upgraded automatically to IGMPv3.
Example
.The following example configures the IGMP version of an IGMP querier on a specific VLAN.
ip igmp snooping mrouter-time-out
The ip igmp snooping mrouter-time-out Interface Configuration (VLAN) mode command configures the
mrouter-time-out. The ip igmp snooping mrouter-time-out Interface Configuration (VLAN) mode command is
console(config)# interface vlan 2
console(config-if)# ip igmp snooping querier address 192.168.1.220
console(config)# interface vlan 2
console(config-if)# ip igmp snooping querier version 2