Allied Telesis AT-S95 CLI (AT-8000GS Series) - Manual (Page 391)

802.1x Commands
Page 391
Command Mode
Interface Configuration (Ethernet) mode
User Guidelines
The command is relevant when multiple hosts is disabled and the user has been successfully authenticated.
Example
The following example forwards frames with source addresses that are not the supplicant address and sends
consecutive traps at intervals of 100 seconds.
dot1x radius-attributes vlan
Use The dot1x radius-attributes vlan Interface Configuration command enables user-based VLAN assignment.
Use the no form of this command to disable user-based VLAN assignment..
Syntax
dot1x radius-attributes vlan
no dot1x radius-attributes vlan
Parameters
This command has no arguments or keywords.
Default Configuration
Disabled.
Command Mode
Interface Configuration (Ethernet) mode
User Guidelines
The command configurationis allowed only when the port is Forced Authorized.
Radius attributes are supported only in the multiple sessions mode (multiple hosts with authentication).
When Radius attributes are enabled and the Radius Accept message does not contain as an attribute the
supplicant’s VLAN then the supplicant is rejected.
Packets to the supplicant are sent untagged.
After successful authentication the port remains as a member in the unauthenticated VLANs and in the Guest
VLAN. Other static VLAN configurations are not applied on the port.
If the supplicant VLAN does not exist on the switch, the supplicant is rejected.
console(config)# interface ethernet 1/g16
console(config-if)# dot1x single-host-violation forward trap 100