Allied Telesis AT-S95 CLI (AT-8000GS Series) - Manual (Page 70)

Page 70
Allied Telesis
AT-8000GS Command Line Interface User’s Guide
show ports security addresses
The show ports security addresses Privileged EXEC mode command displays the current dynamic addresses
in locked ports.
Syntax
show ports security addresses [ethernet interface | port-channel port-channel-number]
Parameters
•
interface — A valid Ethernet port.
• port-channel-number — A valid port-channel number.
Default Configuration
This command has no default configuration.
Command Mode
Privileged EXEC mode
User Guidelines
There are no user guidelines for this command.
Examples
The following examples display dynamic addresses in currently locked ports.
Maximum Maximum addresses that can be associated on this port in Static
Learning mode or in Dynamic Learning mode
Trap Indicates if traps are sent in case of a violation
Frequency Minimum time between consecutive traps
console# show ports security addresses
Port Status Learning Current Maximum
---- -------- -------- ------- -------
1/g1 Disabled Lock - 1
1/g2 Disabled Lock - 1
1/g3 Enabled Max-addresses 0 1
1/g4 Port is a member in port-channel ch1
1/g5 Disabled Lock - 1
1/g6 Enabled Max-addresses 0 10
ch1 Enabled Max-addresses 0 50
ch2 Enabled Max-addresses 0 128