Allied Telesis AT-S95 CLI (AT-8000GS Series) - Manual (Page 119)

Ethernet Configuration Commands
Page 119
Parameters
This command has no arguments or keywords.
Default Configuration
Broadcast storm control is disabled.
Command Modes
Interface Configuration (Ethernet) mode
User Guidelines
Use the port storm-control broadcast rate Interface Configuration (Ethernet) mode command, to set the
maximum allowable Broadcast rate.
Use the port storm-control include-multicast Global Configuration mode command to enable counting
Multicast packets in the storm control calculation.
Examples
The following example enables Broadcast storm control on Ethernet port 1/g5.
port storm-control broadcast rate
The port storm-control broadcast rate Interface Configuration (Ethernet) mode command configures the
maximum Broadcast rate. Use the no form of this command to return to the default configuration.
Syntax
port storm-control broadcast rate rate
no port storm-control broadcast rate
Parameters
•
rate — Maximum kilobits per second of Broadcast and Multicast traffic on a port. (Range: 70 - 6000000
Default Configuration
The default storm control Broadcast rate is12,000Kbits/Sec.
Command Mode
Interface Configuration (Ethernet) mode
User Guidelines
Use the port storm-control broadcast enable Interface Configuration mode command to enable Broadcast
storm control.
The rate is rounded off to the nearest 64 Kbits/Sec (except for 1 - 63 Kbits/Sec which is rounded off to 64 Kbits/
Sec). If the rate is 0, Broadcast packets are not forwarded.
console(config)# interface ethernet 1/g5
console(config-if)# port storm-control broadcast enable